YF-S201 Hall Effect Water Flow Meter / Sensor

YF-S201 Hall Effect Water Flow Meter / Sensor

This sensor sits in line with your water line and contains a pinwheel sensor to measure

how much liquid has moved through it. There's an integrated magnetic hall effect sensor

that outputs an electrical pulse with every revolution. The hall effect sensor is sealed from

the water pipe and allows the sensor to stay safe and dry.

The sensor comes with three wires: red (5-24VDC power), black (ground) and yellow

(Hall effect pulse output). By counting the pulses from the output of the sensor, you can

easily calculate water flow. Each pulse is approximately 2.25 milliliters. Note this isn't a

precision sensor, and the pulse rate does vary a bit depending on the flow rate, fluid

pressure and sensor orientation. It will need careful calibration if better than 10% precision

is required. However, its great for basic measurement tasks!

We have as example Arduino sketch that can be used to quickly test the sensor, it will

calculate the approximate flow of water in liters/hour.

The pulse signal is a simple square wave so its quite easy to log and convert into liters per

minute using the following formula.

Pulse frequency (Hz) / 7.5 = flow rate in L/min.

Features:

• Model: YF-S201

• Sensor Type: Hall effect

• Working Voltage: 5 to 18V DC (min tested working voltage 4.5V)

• Max current draw: 15mA @ 5V

• Output Type: 5V TTL

• Working Flow Rate: 1 to 30 Liters/Minute

• Working Temperature range: -25 to +80℃

• Working Humidity Range: 35%-80% RH

• Accuracy: ±10%

• Maximum water pressure: 2.0 MPa

• Output duty cycle: 50% +-10%

• Output rise time: 0.04us

• Output fall time: 0.18us

• Flow rate pulse characteristics: Frequency (Hz) = 7.5 * Flow rate (L/min)

• Pulses per Liter: 450

• Durability: minimum 300,000 cycles

• 1/2" nominal pipe connections, 0.78" outer diameter, 1/2" of thread

• Size: 2.5" x 1.4" x 1.4"

Connection details:

• Red wire : +5V

• Black wire : GND

• Yellow wire : PWM output.