Original MicroZone MC6C 2.4G 6CH Transmitter With 6CH Receiver and Neck Belt

MicroZone MC6C 2.4G 6CH S-FHSS FSK Transmitter Remote Controller Radio System And SBUS Signal Receiver

User Manual:
Basic Parameters Of Remote Control:
1. Suitable For Use In: Fixed-wing Aircraft Model,Multi-rotor Model,Electric Vehicle, Electric/Model/Tanker;
2. Transmit Power: Less Than Or Equal To 70mW;
3. Transmission Frequency: 2401MHZ–2479MHZ;
4. Ground Control Range: Greater Than 800 Meters;
5. Transmitter Power Supply Requirements: DC 6V(4AA Batteries);
6. Receiver Power Supply Requirements: DC 4.5~6V;
7. The Whole Set Of Weight: 550g;

The Following Information Is A Quick And Easy Operating Procedure For The Microzone
2.4G MC6C Remote Transmitter And Receiver:
1. Turn Off The Transmitter,Connect The Signal Line Of The Electronic Governor To The Third Channel Of The Receiver,And Then Connect The Battery With The Electronic Governor.
2. When The Receiver Is Powered On,The Orange Indicator Light On The Receiver Is Slowly Flashing.
3. With A Small Screwdriver,Press The Small White Switch In The “BIND”,And The Orange
Indicator On The Receiver Changes From Slow Blinking To Fast Flashing.
4. Transmitter Throttle Rocker To The Lowest Position,And Then Open The Transmitter,The Orange Indicator On The Receiver Is Changed From Fast Flashing To Normal Light.
5. When The Orange Indicator Light On The Receiver Is Usually On,The Receiver And Transmitter Are Connected In Place.Aileron Servo,Elevator Servo And Rudder Servo Connected To The Receiver,According To The User’s Aircraft Model Manual.
6. Finally,Make Sure That Your Transmitter Can Fully Bind The Receiver And Check That Each Channel Is Normal.
7. If The Test Fails,Repeat The Whole Process.
8. The “M.BUS” Channel Above The Receiver Connects The Flight Control And The Receiver With Connecting Line.Then,The UAV Is Adjusted And Calibrated According To The Flight Control Tuning Software.(M.BUS Equals S.BUS);

MicroZone MC6C 2.4G 6CH Transmitter:
Channel: 6;
Color: Black / Silver;
Suitable model: fixed wing model airplane, UAV, vehicle, ship;
RF range: 2401MHZ—2479MHZ;
RFpower: less than 100MW;
Working current: less than 120MA;
Working voltage: 4.5–8.5V;
Modulation mode: FSK;
Sensitivity: 1024;
Signal output: 6 PWM signals and 1 SBUS signals;
Analog and external power supply (not more than 8V): YES;
Low voltage alarm mode: LED indicator and buzzer alarm at the same time;
Power : 6V 1.5AA*4;
Adopt the latest FHSS mode in line with European standards;
Authentication standards: FCC, CE_RED;
Package size: 215MM*105MM*220MM;
Weight (gross weight): 550G;

MR6E Mini Reciver:
Size: 42*28*13mm
Weight: 9.5g
Antenna length: 110mm
Output channel: 6 PWM signal channels, 1 SBUS signal channel
Receiving frequency: 2.401MHZ-2.479MHZ
Voltage range: DC3.5V-7.4V
Frequency mode: electric shock frequency
Applicable to MC6C remote control

MC7RB Reciver:
Model: mc7rb
Channel: 7channels AND M-BUS
Power supply: 4.8-6V
Decoding way: 1024 PPM/PCMS
System: 2.4G S-FHSS system
use for MICROZONE 2.4G S-FHSS system Transmitter, it is new receiver